Device Configuration - Proxim Tsunami MP-8100 Series Reference Manual

By typing question mark with the show command in the privileged mode, you can get the show command structure and you
can see the command's description.
System Name# show ?
Possible completions:
access-ctrl
dhcp
ethernet
eventlog
filtering
hostname
http
inventory
ip
kernel-route-tbl
licensed-feature
macacl
monitor-usage
network
qos
running-config
security
snmp
sntp
ssh
statistics
syslog
system-information
system-type
tech-support
telnet
templog
tftp
traphost
vlan
vlan-trunk
wireless
worp-qos

1.5.4 Device Configuration

To configure the device parameters in Global Configuration mode, type ? to list the available commands.
System Name>enable
System Name #configure
System Name(config)#?
Possible completions:
commit
dhcp
ethernet
exit
filtering
macacl
management
monitor
network
qos
radio-mode
radius
reboot
security
system-configure
vlan
wireless
worp-qos
To proceed with configuration, select each interface and enter the required parameters and their configurations.
Tsunami MP-8100 Reference Manual
Access Control,Table Configuration
DHCP Configuration
Ethernet Configuration
Eventlog Configuration
Filtering Configuration
Display the Host Name Information
Http Configuration
Display the Security ID,Inventory Component Table
Display Ethernet Ip/Wireless Ip/Default Gateway Information
Display the Kernel Route Table Information
Display the license feature Information
Mac Acl Configuration
Displaying the CPU,RAM Usage
Network Configuration
QoS Configuration
Display All the Running Configuration
Security Configuration
Display SNMP V3/SNMP read,read write Password Information
Sntp Configuration
SSH Configuration
Statistics Monitoring
Display the Syslog,Hosttable Configuration
Display the System Information
Display the System Type table,Country Code,Forward Mode
Display Technical Support Information
Telnet Configuration
Display the Temperature Log Table Configuration
Tftp Configuration
Display the Trap Host table information
Vlan,SU Vlan Ethernet Configuration
Vlan Trunk Table Configuration
Wireless Status and Configuration
Display the Worp Qos Configuration
Apply the changed configurations to the device
DHCP Configuration
Ethernet Configuration
Exit from configure mode
Filtering Configuration
Macacl Configuration
Management Configuration
Monitor Configuration
Network Configuration
Quality of Service Configuration
Radio Mode Configuration
Radius Configuration
Reboot the device.Set 1 to reboot
Security Configuration
Country Code,Packet Mode Configuration
Vlan Configuration
Wireless Configuration
Worp Qos Configuration
Command Line Interface
14