Proxim Tsunami MP-8100 Series Reference Manual page 15

1.5.4.1 Network
To configure the Network Parameters, use the following commands.
System Name(config)# network
System Name(config-net)# ?
Possible completions:
clear-interface-stats
exit
ip
nat
primary-dns-ip
rip
secondary-dns-ip
static-routes
System Name(config-net)#
Perform the following commands to configure the IP settings. Configuration changes in IP settings takes effect only after
commit and reboot. You can commit and reboot the device using the Commit and Reboot commands.
IP Configuration
System Name(config-net)# ip
System Name(config-net-ip)#?
Ethernet IP Configuration
System Name(config-net-ip)# ethernet-ip-table
System Name(config-net-ip-etherip)# index 1 ipaddress 10.0.0.1
System Name(config-net-ip-etherip)# index 1 mask 255.255.255.0
System Name(config-net-ip-etherip)# index 1 address-type static
System Name(config-net-ip-etherip)#exit
System Name(config-net-ip)#exit
System Name(config-net)#exit
System Name(config)#exit
Note: Here index represents the Ethernet interface.
IP settings on the device can be displayed using the following Show Command.
System Name# show ip
// IP CONFIGURATION //
Ip Address
Mask
Address Type
// IP Gateway //
Gateway IP Address : 169.254.128.1
Tsunami MP-8100 Reference Manual
Clear Interface Statistics
Exits Back to Global Configure Mode
Ether ip/Wireless Ip Configuration
NAT Configuration
Primary DNS IP Address Configuration
Routing Information Protocol
Secondary DNS IP Address Configuration
Static Routes Configuration
: 10.0.0.1
: 255.255.255.0
: static
Command Line Interface
15