Proxim Tsunami MP-8100 Series Reference Manual page 59

System Name(config-monitor)# sntp
System Name(config-monitor-sntp)# day-light-savingtime unchanged
System Name(config-monitor-sntp)# primary-server-name time.nist.gov
System Name(config-monitor-sntp)# secondary-server-name string
System Name(config-monitor-sntp)# sntp-status disable
System Name(config-monitor-sntp)# time-zone dateline
System Name# show sntp
// SNTP CONFIGURATION //
Status
Primary Server Name
Seconday Server Name
Time Zone
Daylight Saving Time
Current Time
1.5.6.4 Syslog and Host Table
Enter the following commands to configure Syslog and Host table:
System Name(config-monitor)# syslog
System Name(config-monitor-syslog)# priority emergency
System Name(config-monitor-syslog)# status enable
System Name(config-monitor-syslog)# reset no
System Name(config-monitor-syslog)# host-table
System Name(config-monitor-syslog-hosttbl)# rowadd 0 entry-status create
System Name(config-monitor-syslog-hosttbl)# rowadd 0 ipaddress 10.0.0.1
System Name(config-monitor-syslog-hosttbl)# rowadd 0 port 80
System Name(config-monitor-syslog-hosttbl)# rowadd 0 comment firstrow
System Name(config-monitor-syslog-hosttbl)# rowadd 0 entry-status create
System Name(config-monitor-syslog-hosttbl)#exit
System Name(config-monitor-syslog)#exit
System Name(config-monitor)#exit
System Name(config)#exit
System Name# show syslog
// SYSLOG CONFIGURATION //
Status
Priority
Reset
// HOST TABLE CONFIGURATION //
INDEX 1
Ip Address
Port
Comment
Entry status : enable
To display the system log messages, use the following command:
System Name# show syslog-messages
To clear the system log messages, use the following command:
System Name# clear syslog-messages
Tsunami MP-8100 Reference Manual
: disable
: time.nist.gov
: string
: dateline
: unchanged
: 01-01-2000
: enable
: emergency
: 0
: 10.0.0.1
: 80
: firstrow
0:53:23
Command Line Interface
59