Proxim Tsunami MP-8100 Series Reference Manual page 17

RIP Config Table Configuration
System Name(config-net-rip)# config-table
System Name(config-net-rip-riptbl)# rowedit 1 authentication-key word
System Name(config-net-rip-riptbl)# rowedit 1 authentication-type none
System Name(config-net-rip-riptbl)# rowedit 1 receive-only no
System Name(config-net-rip-riptbl)# rowedit 1 status enable
System Name(config-net-rip-riptbl)# rowedit 1 version-number v2
System Name(config-net-rip-riptbl)# exit
System Name(config-net-rip)# exit
System Name(config-net)# exit
System Name(config)# exit
RIP Table display when two Ethernet & a Wireless Interface status is Enabled.
System Name# show network rip
// RIP TABLE CONFIGURATION //
INDEX 1
Interface Name
Interface Status
Authentication Type
Authentication Key
Version Number
Receive only
INDEX 2
Interface Name
Interface Status
Authentication Type
Authentication Key
Version Number
Receive only
INDEX 3
Interface Name
Interface Status
Authentication Type
Authentication Key
Version Number
Receive only
Static Route Status and Static Route Table
Static Routes can be configured using the following commands:
System Name(config)# network
System Name(config-net)# static-routes
System Name(config-net-static)#?
Possible completions:
exit
static-route-status
static-route-table
To configure the Static Route Status, use the following command:
System Name(config-net-staticroute)#
Tsunami MP-8100 Reference Manual
Rip Configuration Status : enable
: Ethernet 1
: enable
: none
:
: v2
: no
: Ethernet 2
: enable
: none
:
: v2
: no
: Wireless 1
: enable
: none
:
: v2
: no
Exits Back to Global Configure Mode
Static Route Status Configuration
Static Route Table Configuration
static-route-status enable
Command Line Interface
17