Proxim Tsunami MP-8100 Series Reference Manual page 90

3. Click the Advanced Configuration > System and change the mode of operation from the drop-down menu to
Routing. The unit reconfigures itself to Routing mode without the need to click OK.
4. Click Reboot.
5. Click the Advanced Configuration > Network > IP Configuration.
6. In the IP Configuration screen, you should see that each interface has an IP address. The Ethernet IP address should be
the address the unit had previously. The wireless address is now configurable.
NOTE: To make this work, ALL units must have wireless IPs in the same subnet. The default router address must be the
IP address of the device that is to provide Internet services to the BSU.
7. Click OK.
8. On the RIP tab, set Advertise and Receive drop down menus to RIPv2.
9. Click OK.
10. Click Reboot. We now move on to the SU. First, enable the SU for Routing mode:
11. Log into the SU by placing its IP address into a Web browser address field.
12. When the Web interface is displayed, click the Advanced Configuration link.
13. Click System and change the mode of operation from the drop-down menu to Routing. The unit reconfigures itself to
Routing mode without the need to click OK.
14. Click Reboot.
15. Click the Advanced Configuration link. Click Network.
16. On the Network screen, you will see that its previous IP address is now the Ethernet Address and Wireless IP is now
configurable. Set the Wireless IP to the same subnet as the BSU, and set the Ethernet IP to be compatible with the
target site's subnet.
NOTE: The default router's address must be the BSU's Ethernet IP address when the Internet connection is located
there.
17. Click OK.
18. On the RIP tab, set Advertise and Receive dropdown menus to RIPv2.
19. Click OK.
20. Click Reboot.
The SU should now be configured for routing mode. Repeat these steps for any additional units. For an example, see the
following diagram, which shows the IP configuration of a BSU and SUs where the units will be routing different subnets at
their target locations. RIPv2 is set for Advertise on all units.
The key to understanding how RIP builds the correct routes is in the Gateway's IP setting. The SU's gateway is the Ethernet IP
address of the BSU. The BSU's gateway is the Internet source; that is, switch, router. The Clients at site B and C have their
gateway set to the Ethernet IP address of their respective SU.
Tsunami MP-8100 Reference Manual
Windows IAS RADIUS Server Configuration
89