Proxim Tsunami MP-8100 Series Reference Manual page 26

System Name (config)# wireless
System Name (config-wireless)# properties
System Name (config-wireless-properties)#radio 1 antenna-gain 12
System Name (config-wireless-properties)#radio 1 auto-channel-selection disable
System Name (config-wireless-properties)#radio 1 cellsize large
System Name (config-wireless-properties)#radio 1 channel-wait-time 60
System Name (config-wireless-properties)#radio 1 configured-channel 160
System Name (config-wireless-properties)#radio 1 current-bandwidth 20
System Name (config-wireless-properties)#radio 1 mp-operational-mode highthroughput
System Name (config-wireless-properties)#radio 1 radio-status enable
System Name (config-wireless-properties)#radio 1 satellite-density large
System Name (config-wireless-properties)#radio 1 tpc 12
System Name (config-wireless-properties)#exit
System Name (config-wireless)#exit
System Name (config)#exit
System Name# show wireless properties
// WIRELESS PROPERTIES CONFIGURATION //
INTERFACE 1
Radio Status
Supported Operational Modes
Throughput5GHz
Current Channel Bandwidth
Supported Channel Bandwidth : 20,40
Auto Channel Selection
Current Configured Channel
Current Active Channel
TPC
Cellsize
Antenna Gain
Supported Channels
6,47,48,49,50,51,52,53,54,55,56,57,58,59,60,61,62,63,64,65,66,67,68,69,70,71,72,
73,74,75,76,77,78,79,80,81,82,83,84,85,86,87,88,89,90,91,92,93,94,95,96,97,98,99
,100,101,102,103,104,105,106,107,108,109,110,111,112,113,114,115,116,117,118,119
,120,121,122,123,124,125,126,127,128,129,130,131,132,133,134,135,136,137,138,139
,140,141,142,143,144,145,146,147,148,149,150,151,152,153,154,155,156,157,158,159
,160,161,162,163,164,165,166,167,168,169,170,171,172,173,174,175,176,177,178,179
,180,181,182,183,184,185,186,187,188,189,190,191,192,193,194,195,196,197,198,199
,200,201,202,203,204,205,206,207,208,209,210,211,212,213,214,215
Satellite Density
MP Operational Mode
DFS Channel Wait Time
MIMO
Enter the following command to configure wireless mimo table parameters in Interface 1.
NOTE: Frequency Extension is configurable only if current channel bandwidth is 40MHz.
Tsunami MP-8100 Reference Manual
: enable
: Legacy2.4GHz,HighThroughput2.4GHz,Legacy5GHz,High
: 20 MHz
: disable
: 160
: 160
: 12 dBm
: large
: 12 dBi
: 30,31,32,33,34,35,36,37,38,39,40,41,42,43,44,45,4
: large
: highthroughput
: 60
Command Line Interface
26