High-Voltage Pcb; Pre-Procedure For Removing High Voltage Power Supply Pcb; Removing High Voltage Power Supply Pcb - Canon LBP7200Cdn Service Manual

Chapter 3
5) Remove the cable guide [1].
- 2 claws [2]
6) Remove 1 screw [1] and 1 switch cap [2].
7) Remove the power supply unit [1].
- 5 screws [2]
3-14
F-3-57
F-3-58
F-3-59
CAUTION:
Since the connector is connected to the power unit, do not pull it out
forcibly.
8) Remove 3 connectors [1] from the power supply unit.

3.1.15 High-voltage PCB

3.1.15.1 Pre-procedure for removing high voltage power
supply PCB
1) Remove the right cover.(page 3-3)Reference[Removing right cover]
2) Remove the upper rear cover.(page 3-1)Reference[Removing upper rear
cover (left)]
3) Remove the upper cover.(page 3-5)Reference[Removing upper cover]
4) Remove the left cover.(page 3-4)Reference[Removing left cover]

3.1.15.2 Removing high voltage power supply PCB

1) Open the front cover [1].
F-3-60
F-3-61
0021-3969
0021-3970