Notes On Parameters For Idle Mode And Fault Mode - Festo CPX-FB32 Manual

2. Commissioning
2.4

Notes on parameters for Idle mode and Fault mode

Festo P.BE-CPX-FB32-EN en 1111a
Reaction of the outputs in Idle mode or Fault mode
The Idle mode is assumed by the stations after request by the
master.
The Fault mode defines the status the relevant channel is to
assume in the event of fieldbus communication faults.
In this status, the following applies:
– Inputs are transmitted.
– Output channels of the stations are no longer updated.
In the Idle mode or Fault mode, outputs can assume one of
the following states:
Digital outputs/valves
Freeze current status
Reset output
Set output
Tab. 2/17: Possible states in the Idle or Fault mode
You can determine the status to be assumed for each
output channel (output or solenoid coil) separately.
The standard setting is "Reset of the output channel".
Further information can be found in the CPX system
description.
Analogue outputs
Freeze current status
Desired analogue value
2-39