Settingthe Dil Switches - Festo CPX-FB32 Manual

1. Installation

1.2.2 Settingthe DIL switches

1
DIL switch 1:
Operating mode
2
DIL switch 2:
Diagnostic mode
or number of I/O
bytes for Remote
Controller
3
DIL switch 3:
IP addressing
Fig. 1/3: DIL switch in the fieldbus node
1-8
You can set the following parameters with the DIL switches
under the cover (see Fig. 1/3):
– Operating mode
– Diagnostic mode or number of I/O bytes
– IP addressing
Procedure:
1. Switch off the power supply.
2. Remove the cover over the DIL switches (section 1.2.1).
3. Carry out the setting as described on the following pages.
4. Mount the cover again (section 1.2.1).
1
Festo P.BE-CPX-FB32-EN en 1111a
2
3