Overview Of Configuration On The Ethernet/Ip - Festo CPX-FB32 Manual

2. Commissioning

2.2.2 Overview of configuration on the EtherNet/IP

Festo P.BE-CPX-FB32-EN en 1111a
Note
From CPX-FB32 Revision 17, the "Major Revision" was
raised from 1 to 2. For "Major Revision" 2, a new EDS file
must be used or the corresponding setting made in the
controller.
Nodes with "Major Revision" 2 are downward compatible
with "Major Revision" 1
The EDS file suitable to your CPX-FB32 can be determined
and downloaded at www.festo.com in the Festo Support
Portal.
Note
If the station features are entered manually, individual
parameterisation of the CPX terminal is not possible.
When the EDS library has been expanded, the CPX terminal is
entered in the station list as a possible EtherNet/IP station.
It can now be added to a network.
When the station features have been configured
(e.g. by installation of the EDS file), the following steps are
required for parameterisation (depending on the
configuration program):
1. Install your CPX terminal and set the network addressing
according to section 1.3.3.
2. Create a connection to an EtherNet/IP station.
With RSLogix, use for this the profile
"Generic Ethernet Device".
2-23