Set Up A Listen-Only Connection - Festo CPX-FB32 Manual

2. Commissioning

2.2.3 Set up a listen-only connection

2-24
3. Assign the instances of the Assembly Object:
Instance 101: Inputs
Instance 100: Outputs
Instance 102: Configuration data, if used
("Configuration Assembly")
4. Select the data format SINT.
5. Enter the IP address, if necessary.
When the station features have been configured
(e.g. by installation of the EDS file), the following steps are
required for parameterisation (depending on the
configuration program):
1. Install your CPX terminal and set the network addressing
according to section 1.3.3.
2. Create a connection to an EtherNet/IP station.
With RSLogix, use for this the profile
"Generic Ethernet Device".
3. Assign the instances of the Assembly Object:
Instance 101: Inputs
Instance 1 Outputs
Instance 102: Configuration data, if used
("Configuration Assembly")
4. Select the data format Input Data – SINT.
5. Enter the IP address, if necessary.
Festo P.BE-CPX-FB32-EN en 1111a