Parameterisation Via Configuration Assembly (Method 1) - Festo CPX-FB32 Manual

2. Commissioning

2.3.2 Parameterisation via Configuration Assembly (method 1)

2-32
With parameterisation via the Configuration Assembly, the
parameters must be entered individually in the control
program or generated via software.
Parameterisation via the Configuration Assembly is available
only for revision statuses later than Rev. 1.10.
Further information on creation of the Configuration
Assembly can be found at www.festo.com/fieldbus.
Simplified parameterisation in RSLogix5000
With the help of the CPX Festo Maintenance Tool (CPX-FMT), it
is possible to export the configuration of a CPX terminal with
EtherNet/IP bus node into an RSLogix5000 project.
The CPX-FMT is available in the internet at
www.festo.com/fieldbus.
1. Establish a connection between CPX-FMT and the CPX
terminal through the Ethernet.
2. Manually configure the CPX terminal with the CPX-FMT or
use the online function to download the configuration
automatically.
3. Change the parameters to the extent needed
(all parameters can also still be changed after
export/import into RSLogix).
Festo P.BE-CPX-FB32-EN en 1111a