Use For Intended Purpose - Festo CPX-FB32 Manual

Contents and general instructions

Use for intended purpose

VI
The fieldbus node documented in this descriptionCPX-FB32 is
intended solely for use as a station on the EtherNet/IP.
The CPX terminal must only be used as follows:
– as intended in an industrial environment
– in original status without unauthorised alterations.
Only the conversions or modifications described in the
documentation supplied with the product are permitted.
– in perfect technical condition.
The limit values specified for pressures, temperatures,
electrical data, torques etc. must be observed.
If additional commercially available components such as
sensors and actuators are connected, the specified limits for
pressures, temperatures, electrical data, torques, etc. must
not be exceeded.
Observe the regulations of the trade associations,
German Technical Control Board (TÜV), VDE stipulations or
corresponding national laws and regulations.
Festo P.BE-CPX-FB32-EN en 1111a