Festo CPX-FB32 Manual page 43

2. Commissioning
Input/output modules and system diagnostics
1. I/O diagnostic interface, if set
2. Number of input modules CPX-4DE
3. Number of input modules CPX-8DE, -8NDE, 8DE-D + __ x 8 I
4. Number of input modules CPX-16DE
5. Number of output modules CPX-4DA
6. Number of output modules CPX-8DA
7. Number of Multi I/O modules CPX-8DE-8DA
8. Number of analogue input modules CPX-2AE-U-I
9. Number of analogue input modules CPX-4AE-I + __ x 64 E/ x 32 I +
10.Number of analogue input modules CPX-4AE-T
11.Number of analogue output modules
CPX-2AA-U-I
12.Number of inputs and outputs of other modules
(e.g. CP interface)
13.Midi/Maxi, CPA or VTSA pneumatic interface:
Number of configured valve solenoid coils
(+8 O, 16 O, 24 O, 32 O)
Configured at the factory is 32 O (Midi/Maxi, VTSA) or 24 O (CPA)!
14.Number of MPA1 or MPA2 pneumatic modules
15.Total number of Inputs/Outputs to be configured
Total of 1. to 14.:
1)
8 bits are always assigned (4 remain unused).
Tab. 2/6: Ascertaining the number of inputs and outputs
Festo P.BE-CPX-FB32-EN en 1111a
Calculating the number of inputs/outputs
Use the following table for calculating the number of inputs
and outputs on your CPX terminal.
+ __ x 8 I/O
Inputs
+ 16 I/O + _____ I
1)
+ __ x 8I + _____ I
+ _____ I
+ __ x 16I + _____ I
1)
+ __ x 8O
+ __ x 8 O
+ _____ I
+ __ x 32 I + _____ I
_____ I
+ __ x 64 I + _____ I
+ __ x 32 O
+ __ I/O + _____ I
1)
+ __ x 8 O
= ∑ _____ I
Outputs
+ _____ O
+ _____ O
+ _____ O
+ _____ O
+ _____ O
+ _____ O
+ _____ O
+ _____ O
= ∑ _____ O
2-9