Notes On Parameterisation - Festo MSE6-E2M Operating Instruction

Parameterisation
2
1
Fig. 29: Parameterisation of the MSE6-E2M
1
Interface module or network scanner/bus
master; the desired parameterisation can
be guaranteed e.g. in the start-up phase or
after fieldbus interruptions.
2
User program in the machine controller;
parameters can be modified during opera-
tion.
9.2

Notes on parameterisation

This documentation describes the module parameters of the energy efficiency module. For a detailed
description of the system parameters, diagnostic memory parameters, data and application principles,
see CPX system description è 1 Applicable documents
Time behaviour with parameter changes
Due to calculations that are required in some cases, modified parameters are not valid until they have
been thoroughly checked and saved. After a change of value valid input data will not be available for
up to a maximum 30 ms, depending on the parameter.
58
3
Network-specific configurators; parameters
can be modified during the commissioning
phase or during troubleshooting.
4
Service interface
Festo — MSE6-E2M — 2022-08d
3
4