Pu Operation Mode - Mitsubishi Electric FR-D720S SC EC Instruction Manual

Basic settings
5.2

PU operation mode

When operating the inverter via the parameter unit, the motor is started or stopped by the RUN
key or the STOP/RESET key on the unit. The rated frequency value can thereby originate from
various sources:
● A fixed set value
Operation at the frequency set in the frequency setting mode of the PU. (Refer to section
5.2.1.)
● Operation using the digital dial as the volume
The frequency is set by the digital dial, used here as a potentiometer. (Refer to section 5.2.2.)
● Selection of stored set values by external signals
Change of frequency with ON/OFF switches connected to terminals. (Refer to section 5.2.3.)
● Setpoint setting made by external analog signals
Frequency setting with a voltage output device (section 5.2.4) or with a current output device
(section 5.2.5).
FR-D700 SC EC
Inverter
Operation panel
Fig. 5-10:
PU operation mode
PU operation mode
I002086E
5 - 21