Pu Operation Mode (Operation Using The Operation Panel (Fr-Du04)) - Mitsubishi Electric FR-F500 Instruction Manual

3.4.3 PU operation mode
(Operation using the operation panel (FR-DU04))
( 1 ) Operation at 60Hz
While the motor is running, repeat the following steps 2 and 3 to vary the speed:
Step
Power-on → Operation mode check
Switch power on and make sure that the operation command indication "PU" is lit.
(If it is not lit, switch to the PU operation mode. For operation mode changing, refer to
page 102.)
1
Running frequency setting
Set the running frequency to 60Hz.
First, press the [MODE] key to select the frequency setting mode. Then, press the
[UP/DOWN] key to change the setting, and press the [SET] key to write the
2
frequency.
Start
Press the [FWD] or [REV] key.
The motor starts running. The monitoring mode is automatically selected and the
output frequency is displayed.
3
Stop
Press the [STOP] key.
The motor is decelerated to a stop.
4
( 2 ) PU jog operation
Hold down the [FWD] or [REV] key to perform operation, and release it to stop.
1) Set Pr. 15 "jog frequency" and Pr. 16 "jog acceleration/deceleration time".
2) Select the PU jog operation mode.
3) Hold down the [FWD] or [REV] key to perform operation.
(If the motor remains stopped, check Pr. 13 "starting frequency". The motor will not start if its setting is lower
than the starting frequency.)
Description
53
OPERATION
Image
ON
REV FWD
(or)
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
(or)
FWD REV
REV FWD
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
3