Monitor display and monitor output signals
NOTES
By setting "0" in Pr. 52, the monitoring of output speed to alarm display can be selected in
sequence by the SET key.
When the operation panel is used, the displayed units are Hz and A only and the others are
not displayed.
The monitor set in Pr. 52 is displayed in the third monitor position. However, change the out-
put current monitor for the motor load factor.
The monitor displayed at powering on is the first monitor. Display the monitor to be displayed
on the first monitor and press the SET key for 1s. (To return to the output frequency monitor,
hold down the SET key for 1s after displaying the output frequency monitor.)
Power on monitor (first monitor) Second monitor
Output frequency
Fig. 6-60: Displaying various types of monitor
Example
When Pr. 52 is set to "20" (cumulative energizing time), the monitor is displayed on the oper-
ation panel as described below.
Power on monitor (first monitor) Second
Output frequency
Fig. 6-61: Selection of the third monitor
6 - 114
Third monitor
Output current
Output voltage
Third monitor
Cumulative energizing time
Output current
Parameter
Alarm monitor
With
fault
I001800E
Alarm monitor
With
fault
I001801C