Easy Operation Mode Setting (Easy Setting Mode) - Mitsubishi Electric FR-D720-0.2K-G Instruction Manual

Operation panel
4.1.3

Easy operation mode setting (easy setting mode)

Setting of Pr. 79 Operation mode selection according to combination of the start command and speed command can be
easily made.
Changing
Start command: external (STF/STR), speed command: operate with
example
1.
Screen at power-ON
The monitor display appears.
2.
Easy operation mode setting
Press and
3.
Operation mode selection
Turn until "
(Refer to the table below for other settings.)
4.
Operation mode setting
Press to set.
REMARKS
" " is displayed ... Why?
Setting cannot be made during operation. Turn the start switch (
 If is pressed before pressing
display. If the easy setting mode is terminated while Pr. 79 = "0 (initial setting)," the operation mode switches between the PU
operation mode and the External operation mode. Check the operation mode.
 Reset can be made with
 The priorities of the speed commands when Pr. 79 = "3" are "Multi-speed operation (RL/RM/RH/REX) > PID control (X14) >
terminal 4 analog input (AU) > digital input from the operation panel".
52
Operation
for 0.5s.
" appears.
Operation Panel Indication
Blinking
Blinking
Blinking
Blinking
Blinking
Blinking
Blinking
Blinking
, the easy setting mode is terminated and the display goes back to the monitor
.
Operation Mode
Start command Speed command
External Analog
(STF, STR) voltage input
External
(STF, STR)
Analog
voltage input
Blink ··· Parameter setting complete!!
The monitor display appears after 3s.
, STF or STR) OFF.
Display
Blinking
Blinking
Blinking