Fresenius Medical Care 2008K Operator's Manual page 182

182
TMP is Low (alarm at or The TMP has exceeded the TMP low
below 60) alarm limit value.
Tx Clock Paused? Blood is sensed in optical detector
while Tx clock is paused
UF Goal greater than Entry value for goal is out of range.
max. value
UF Goal Reached This message is to alert the operator
that the preset ultrafiltration goal has
been reached.
UF Is On An action has been initiated that
requires the UF to be off.
UF Profile Error A UF profile calculation error has
been detected
Chapter 6—Alarms and Troubleshooting
2008K Hemodialysis Machine Operator's Manual Rev P
Blood 1) Ensure that the venous transducer protector is dry and the
Alarm monitor line is open. Replace the transducer protector, if
necessary.
2) Check the dialyzer supply and return lines for kinks.
3) Check the filter screen in the dialyzer return line to make sure it is
clean.
4) Press RESET key to reset alarm. Press the Override key and
hold for one second to select new alarm limits or for adjusting the
TMP.
Note: Increasing the UF rate can also raise the TMP.
Administer saline as prescribed. Notify a physician if the
UF rate has changed.
Note: Lowering the venous pressure by reducing the
blood flow rate can also be effective, if using a high-
permeable dialyzer. Notify a physician if the blood flow
rate has changed.
5) If unable to reset the alarm, return the blood to the patient if
alarm occurs during treatment. Take the machine out of service
and alert a qualified service technician.
Warning Start Tx clock
Dialog Readjust UF Goal
Message
Warning Press RESET to reset the alarm. The preset UF Goal has been
reached and the UF Rate will drop to the minimum UF Rate. If the
patient's prescribed UF Goal has not been reached, the operator
must take further action to comply with the prescribed treatment.
Advisory To proceed with the selected operation, turn the UF pump off.
Alarm Reset the UF parameters