Fresenius Medical Care 2008K Operator's Manual page 158

158
Conductivity out of range When attempting to start an OLC test,
certain conditions are necessary,
including the condition that
conductivity for both the inlet and
outlet sensors be in range
CONFIRM Concentrate This message will be displayed if the
user needs to confirm the concentrate
selected for use
Connector(s) Out Of Port An action has been initiated that
requires the Acid/Bicarbonate
Connectors to be in their rinse ports
Cooling Down The machine is cooling down from a
heat disinfect.
** Cover is Open ** The dialysate shunt door is open.
Cuff Pressure = XXX This is displayed during the blood
pressure measurement. The cuff
pressure is XXX mmHg.
Dial Valve Failure 1 Electronic self-test failure.
Dial Valve Failure 2 Electronic self-test failure.
Chapter 6—Alarms and Troubleshooting
2008K Hemodialysis Machine Operator's Manual Rev P
Advisory Wait until the conductivity is stable and start the OLC test again. If
the message repeats, do not use OLC until the conductivity sensors
have been recalibrated.
Advisory Press CONFIRM or change the concentrate selection and then press
CONFIRM.
Warning Insert the concentrate connectors into their proper rinse ports.
Advisory Advisory message only. No action is required.
Advisory To proceed with the selected operation, close the shunt door.
Dialog No action is necessary.
Message
Alarm Turn machine power off and back on. If alarm does not clear, return
the blood to the patient if alarm occurs during treatment. Take the
machine out of service and alert a qualified service technician.
Alarm Turn machine power off and back on. If alarm does not clear, return
the blood to the patient if alarm occurs during treatment. Take the
machine out of service and alert a qualified service technician.