Fresenius Medical Care 2008K Operator's Manual page 178

178
Set Venous Limits This is a message to adjust the
venous limits if necessary
Short Power Down The machine was switched off for 1 –
2 minutes and turned back on. Setup
values have not been set to default
values.
Single Needle On! An action has been initiated that
requires the Single Needle option to
be off.
SN BP +5 V Error + 5 volts is outside the allowable
range
SN BP +12 V Error + 12 volts is outside the allowable
range
SN BP -12 V Error - 12 volts is outside the allowable
range
SN BP +24 V Error + 24 volts is outside the allowable
range
SN BP Button Alarm Key stuck or held in too long
SN BP Comm. Timeout Time out when receiving Intel-Hex-
line or overflowed received buffer
SN BP Del. Rate Alarm Actual speed-read back analog
voltage at X348/10 is out of limits
SN BP Direction Alarm Pump is turning in the wrong direction
SN BP EEPROM Error EEPROM error
SN BP EPROM Error EPROM CRC error
SN BP Erasing Error Error erasing Flash ROM while in
Service Mode
SN BP Flash Error Error copying data into Flash ROM
while in Service Mode
SN BP Level Up Alarm Pressure increase when the Level Up
key is pressed
Chapter 6—Alarms and Troubleshooting
2008K Hemodialysis Machine Operator's Manual Rev P
Advisory Press and hold RESET for 1 second to adjust the limits. Changes in
venous pressure during the treatment should be investigated. See
"Venous Pressure Alarm"
Advisory Verify that the dialysis parameters are as desired.
Warning To proceed with the selected operation, de-select the Single Needle
option.
Alarm See message E.10
Alarm See message E.07
Alarm See message E.09
Alarm See message E.08
Alarm See message A.16
Alarm See message A.27
Alarm See message A.21
Alarm See message A.13
Alarm See message E.05
Alarm See message E.01
Alarm See message E.98
Alarm See message E.97
Alarm See message A.25