Fresenius Medical Care 2008K Operator's Manual page 177

Chapter 6—Alarms and Troubleshooting
Message Purpose of Message
RTD = Zero The RTD (Remaining Time on
Dialysis) clock has counted down to
zero.
Running Diasafe Test
This message is advising the operator
of the status of the Diasafe test
Running Online PHT This message is displayed when the
online Pressure Holding Test is in
progress.
Run Access Flow? This message is a prompt for the
operator begin the Access Flow test.
Select Concentrate This message is a prompt for the
operator to select a concentrate.
Select new goal or rate UF time is out of range.
Select new Goal or Time UF rate is out of range.
Select Program This message is a prompt for the
operator to select a program.
Set Arterial Limits This is a message to re-center the
arterial limits if necessary
Set Blood Flow to 300 This message is a prompt for the
operator to set the blood flow rate in
preparation for the Access Flow test
Set TMP Limits? This is a message to re-center the
TMP limits if necessary
177
Type Action Required
Warning Reset the alarm. This message has alerted the operator that the
preset time on dialysis has elapsed (RTD = 0:00). If prescribed
treatment time has not been completed, the operator must take
further action to comply with the prescribed treatment.
Advisory Advisory only. No action is required.
Advisory Advisory only. No action is required.
Warning To proceed now, press CONFIRM. To delay, press Escape. To
cancel, go to the "Kt/V AF" screen and toggle the Access Flow check
box to Off.
Advisory
To select a concentrate from the menu, use the
keys on the control panel to highlight the desired concentrate, and
press CONFIRM. For more information, see Chapter 3, "Setting an
Acid/Bicarbonate Type."
Dialog Enter a new UF Goal or reduce UF time.
Message
Dialog Enter a new UF Goal or reduce UF rate.
Message
Advisory To proceed, select the desired program and press CONFIRM.
Advisory Press and hold Reset for 1 second to re-center the limits.
Warning To proceed, set Blood Flow to 300 and press CONFIRM.
Advisory Rising TMP may indicate a leak in the balancing system and should
be investigated.
Press and hold Override for 1 second to re-center the limits.
2008K Hemodialysis Machine Operator's Manual Rev P

 (
or Up/Down)