Fresenius Medical Care 2008K Operator's Manual page 145

Chapter 6—Alarms and Troubleshooting
Message Purpose of Message
A.25 (Arterial or SN Pressure increase when the Level Up
Blood Pump Message) key is pressed
A.26 (Arterial Blood Pressure was adjusted too much in
Pump Message) calibration mode
A.27 (Arterial Blood Time out when receiving Intel-Hex-
Pump Message) line or overflowed received buffer
A.28 (Arterial Blood Error in received Intel-Hex-line
Pump Message)
A.29 (Arterial Blood Pump rotor turning when it should not
Pump Message) be
Access Flow Complete This message is an advisory
message that the Access Flow test is
complete
Access Flow Running This message is an advisory
message that the Access Flow test
process is continuing.
Access Flow Test This message is an advisory
Scheduled message that the Access Flow test
process is continuing.
Acetate Selected! Acetate concentrate has been
selected and the blue bicarbonate
wand/connector is out of its port.
145
Type Action Required
Alarm Press the RESET key to clear. Possibility that the level adjust pump
is connected backward so that the level is lowered instead of raised.
Verify that the level in the arterial chamber rises when the adjust key
is pressed. If it does not, return the blood to the patient if alarm
occurs during a treatment. Take the machine out of service and alert
a qualified service technician.
Alarm Press the RESET key if this message occurs in dialysis mode. If this
alarm occurs during a treatment, return the blood to the patient. Take
the blood pump module out of service and alert a qualified service
technician.
Alarm Press the RESET key if this message occurs in dialysis mode. If this
alarm occurs during a treatment, return the blood to the patient. Take
the blood pump module out of service and alert a qualified service
technician.
Alarm Press the RESET key if this message occurs in dialysis mode. If this
alarm occurs during a treatment, return the blood to the patient. Take
the blood pump module out of service and alert a qualified service
technician.
Alarm Press the RESET key to clear. If problem persists, manually return
the blood to the patient (see page 118 for instructions). Take blood
pump module out of service and alert a qualified service technician.
Warning Press CONFIRM to clear the message
Advisory No action is necessary
Advisory No action is necessary
Warning Connect blue (bicarbonate) wand/connector into the blue rinse port.
Be sure the concentrate selection is correct.
2008K Hemodialysis Machine Operator's Manual Rev P