Reduction Gear For Electric Starter - Rotax 912 Series Maintenance Manual

3.7)

Reduction gear for electric starter

Effectivity 912/914 Series
Edition 1 / Rev. 0
BRP-Rotax
Maintenance Manual
See Fig. 72-16.
Place thrust washer (1) 12.5/21.5/1 on the crankcase. Place interme-
diate gear (2) in position, oil intermediate gear shaft (3) and push into
position. Place thrust washer (4) 12.5/21.5/1 on top.
Check the geartooth system of the intermediate gear (5). If the gear-
tooth system is deformed, the intermediate gear must be replaced.
◆ NOTE:
If the teeth of the intermediate gear are deformed, a
noise will be produced when the engine is started.
Fig. 72-16
3
4
2
5
1
00240
72-00-00
page 20
May 01/2007