Setup Support Mode; Switching Operation To Setup Support Mode - IDEC WB2F User Manual

1. Overview 2. Installation & wiring
4. 3

Setup support mode

This mode is used to check the installation position and reading status of the WB2F.
Setup support mode has the following function.
Reading Success Rate Measurement ...............
z
Decoding Processing Time Measurement .....
z
Symbol Placement Measurement .....................
z
Auto-Tuning ..............................................................
z
4. 3. 1

Switching operation to setup support mode

There are two methods to switch to setup support mode.
Use the methods according to the situation.
Method 1
You can switch to setup support mode with the Operation button.
For details, refer to
Method 2
You can switch to setup support mode with control commands.
For detail, refer to
3 Operational Check
F Page 4-44
F Page 4-45
F Page 4-46
F Page 4-48
F [Detailed procedure using the READ/ENTER and SELECT buttons]
F [5. 6 List of Control Commands]
4-41
Function
on page 5-13.
5. Appendix
Setup support mode
on page 4-42.