Table of Contents
Advertisement
1. Overview
2. Installation & wiring
4. 3. 4
Symbol Position Measurement
Will read a symbol and output code location information.
The quiet zone is not included in position information.
The measurement results can be checked with the communication interface and the Position LEDs.
Measurement result output is as follows.
(x1,y1)(x2,y2)(x3,y3)(x4,y4) [ Position Display LED Status] Code:[ Read Result Data] CR
*1 (x1, y1) to (x4, y4) : Symbol vertex coordinates
*2 At this time, the global prefix is fixed as "none" and the global suffix is fixed as " CR
Coordinates are defined as follows.
(0,0)
(x1,y1)
(x4,y4)
(0,Ymax)
y
Coordinate ouput order will differ based on symbol orientation.
e.g. If Position Information is ("x1,y1)(x2,y2)(x3,y3)(x4,y4)=(0451,0166)(0742,0171)(0740,0450)(0438,0446)", and Read data
is "IDEC Auto-ID".
(0451,0166)(0742,0171)(0740,0450)(0438,0446) 12-- Code:IDEC Auto-ID CR
At the start of the measurement, the "*** Label Position *** CR
z
cation interface.
To stop the measurement, push the READ/ENTER button or input the communication command suffix. (The
z
initial value is CR
When ended, the WB2F returns to the operation mode before the switch.
z
3 Operational Check
(Xmax,0)
(x2,y2)
(x3,y3)
(Xmas,Ymax)
(x1,y1)
(x2,y2)
(x4,y4)
(x3,y3)
LF ).
4-46
Function
x
Xmax, Ymax will vary depending on
z
settings.
For more details on vertex coordinates
z
(x1, y1) refer to
bels]
on
page
5-28.
(x3,y3)
(x4,y4)
(x2,y2)
(x1,y1)
LF
(2)
(1)
(3)
(4)
Position LEDs
LF " message is output to the communi-
5. Appendix
Setup support mode
LF
LF ".
F [5. 13 Sample la-
Advertisement
Table of Contents
