Table of Contents
Advertisement
1. Overview
Installation & wiring
2. 2
Mounting methods
2. 2. 1
WB2F mounting methods
1
Double check the dimensions of the mounting hole and drill a hole in the mounting board
For the dimensions of the mounting hole, refer to
2
If you use the brackets provided, use the two mounting screws (also provided) to secure the bracket to the
WB2F before you secure the bracket to the mounting board.
If you do not use the brackets provided, use the two mounting screws to secure the WB2F to the mounting
board.
The tightening torque for the product mounting screws is 0.4 to 0.5 N·m.
Mounting Bracket
(Included)
Instead, use two M3 screws with an effective thread length of 3 to 5 mm and secure the WB2F to the
z
plate.
If you use a bracket other than the one that was included, make sure that the dimensions of the
z
mounting holes is at most Φ3.4mm
When using the WB2F, remove the protective film on the scan window.
z
If you attach to a plate that is thicker than 2.3 mm, do not use the included mounting screws.
z
If, during installation, the WB2F is exposed to excessive force (e.g. the mounting screws are
z
tightned excessively, the product is hit with a hammar, the base of the cable is exposed to exces-
sive stress (pulled strongly, bent etc.)), it could undermine the IP65 protective structure of the
WB2F.
3. Operational Check
F [5. 3 Dimensional outline drawings]
Mounting Screws (Included)
M3 SEMS x 6 (2 screws)
2-3
4. Function
5. Appendix
Mounting methods
on
page 5-7.
Advertisement
Table of Contents
