IDEC WB2F User Manual page 38

1. Overview 2. Installation & wiring
Setup support mode
„
This mode is used to check the installation position and reading status of the WB2F. Setup support mode has the follow-
ing function.
Function
Read Success Rate Measurement
Decode Processing Time Measure-
ment
Symbol Position Measurement
Auto-tuning
Maintenance mode
„
This mode is used to maintain the WB2F after installation and to perform actions when problems occur. Maintenance
mode has the following functions.
Function
Maintenance support
Firmware updating
Master mode
„
This mode is used to connect to a PLC with using its communication protocol.Master mode has the following functions.
Function
PLC connection
3 Operational Check
Details
This function outputs and displays Read Success Rate for a giv-
en symbol.
This function outputs and displays the minimum, maximum
and average symbol decoding time.
This function outputs and displays a symbol's position infor-
mation (coordinates)
This function automatically adjusts settings to optimal param-
eters for a given symbol and saves the settings in a parameter
table.
Details
This function forcibly operates the unit with the factory default
settings.
This function updates the WB2F firmware.
Details
This function directly write reading results into the data mem-
ory of a PLC (programmable logic controller).
4-2
Function 5. Appendix
Reference page
F Page 4-44
F Page 4-45
F Page 4-46
F Page 4-48
Reference page
F Page 4-52
F Page 4-52
Reference page
F Page 4-53
Overview