Wiring Instructions: Setting Up The Wb2F Without The Communication Unit - IDEC WB2F User Manual

1. Overview Installation & wiring
2. 3. 2

Wiring Instructions: Setting up the WB2F without the Communication Unit

z Connector Pin Assignment
The WB2F's connector pin assignment is as follows.
DIN Connector
13 9 5 1
12 8 4
Either the DIN Connector Shell or the Cable Shield is not connected to the main body
Make the determination to connect to FE or SG depending on the level of surrounding noise
3. Operational Check
Pin Number Wire color
1 Gray
2 Gray
3 White
4 White
5 Orange
6 Pink
7 Orange
8 Orange
9 Orange
10 Pink
11 Yellow
12 Yellow
13 –
2-12
4. Function
Discription
Red Dot OUT0 External Output 0
Black Dot OUT1 External Output 1
Red Dot OUT2 External Output 2
Black Dot OUT3 External Output 3
Red Dot2 +5V Power Supply +
Black Dot TXD RS-232 Transmission Data
Red Dot IN0 External Input 0
Black Dot IN1 External Input 1
Black Dot2 0V Power Supply (- SG Shared)
Red Dot RXD RS-232 Received Data
Red Dot CTS RS-232 Control Signal
Black Dot RTS RS-232 Control Signal
– NC No connection
5. Appendix
Wiring
Function