Slave Mode; Switching Operation To Slave Mode - IDEC WB2F User Manual

1. Overview 2. Installation & wiring
4. 2

Slave Mode

This operation mode is used during normal operation. Use the unit in this mode after installation.
Slave mode has the following functions.
Symbol reading .......................................................
z
Output data additional information ................
z
Output data editing ...............................................
z
Verification ................................................................
z
Command alias ........................................................
z
Communication command .................................
z
Paramter Changeover ...........................................
z
Image Capture.. .......................................................
z
Image Filter ...............................................................
z
I/O .................................................................................
z
4. 2. 1

Switching operation to slave mode

There are two methods to switch to slave mode.
Use the methods according to the situation.
The status LEDs (red/orange/green) will turn off when switching to slave mode.
Method 1
Turn on the power to the unit. (Do not push the READ/ENTER button)
Turn on power supply
Method 2 Input the "switch to slave mode" control command.
Control command
Host device
Switch to slave mode
3 Operational Check
F Page 4-5
F Page 4-15
F Page 4-20
F Page 4-22
F Page 4-26
F Page 4-28
F Page 4-31
F Page 4-34
F Page 4-37
F Page 4-40
4-4
Function 5. Appendix
Status LED
(R) (O) (G)
OFF
Status LED
(R) (O)
OFF
Slave Mode
(G)