IDEC WB2F User Manual page 66

1. Overview 2. Installation & wiring
z Setup Command
By inputting setup commands from the host device into the WB2F, you can change/view setting parameter values.
Control Command output format is as follows.
e.g. Obtain the settings for Address 0157 "Status LED (Red) Illumination Time".
Request (Host Device → WB2F)
z
Prefix
^
Response(WB2F → Host device)
z
Normal Response
Prefix
^
Abnormal Response
Prefix
^
e.g. Change the settings for Address 0157 "Status LED (Red) Illumination Time".
Requst (Host device → WB2F)
Prefix
^
Response(WB2F → Host device)
z
Normal Response
Prefix
^
Abnormal Response
Prefix
^
If an issue, such as the wrong command is input, occurs the response will become abnormal.
z
Address Range is 0000H-FFFFH (16bit, hex).
z
Data Range is 00H-FFH (8bit, hex).
z
Address at the time of request can be either lowercase or uppercase.
z
Response address will be in lower case (default) but can be changed to uppercase.
z
You can add a check digit to set up command requests and responses.
z
For other settings, refer to
z
Setup Command Response time is within 1s.
z
3 Operational Check
Mnemonic Address
g 0157
Mnemonic Address
g 0157
Judge
NG-ff
Mnemonic Address
s 0157
Judge
OK-00
Judge
NG-ff
F [4. 6 Configuration Item Table]
4-30
Function
Data Type Suffix
x CR LF
Data Type Data
x 1e
Suffix
CR LF
Data Type Data
x 3c
Suffix
CR LF
Suffix
CR LF
on page 4-54.
5. Appendix
Slave Mode
Suffix
CR LF
Suffix
CR LF