IDEC WB2F User Manual page 54

1. Overview 2. Installation & wiring
z Examples: (Additional Information)
Item
Global Prefix
Local Prefix
Data size
Elapsed time
AIM ID
Position Information
Number of Characters
3 Operational Check
Examples:
(Additional
Information)
Suffix with a maximum of 8 characters that can be added to any data out-
^
put.
Suffix that can be added to each symbol type. A maximum of 4 characters
P00;
can be added.
Output Data size increases in 1 byte increments.
1234 It will be expressed in 4 digit decimal form. Zero suppress is not per-
formed.
Elapsed time since powering on the main unit will be added in the form
12:34:56 HH:MM:SS. If reset it will revert back to "00:00:00" The time after 23:59:59
will also revert back to "00:00:00"
Will add the symbol data's AIM ID. If read failure occurs, "]--" will be added
]E0
instead.
Adds the symbol's position information in coordinate form. The function
will not include the quiet zone in position information.
Output format : (x1, y1)(x2, y2)(x3, y3)(x4, y4))
* (x1, y1) to (x4, y4) : symbol vertex coordinates
Can add "P=" (where P is the coordinates) prior to the digit.
Coordinate definition will be as follows:
(0,0)
(x1,y1)
P=
(x4,y4)
(0000,0000)
(1279,0000)
(1279,0959)
(0000,0959)
(0,959)
y
Coordinate ouput order will differ based on symbol orientation
(x1,y1)
(x4,y4)
To obtain vertex coordinates for each type of code refer to
Sample labels]
Will add the symbol data's number of characters.
Will be expressed as a 4 digit decimal number. Zero suppression is not
N=0123
performed.
Can add "N=" (where N is the symbol length) prior to the digit
4-18
Function
Note
(x=0 to 1279)(, y=0 to 959)
(x2,y2)
(x3,y3)
(x2,y2) (x3,y3)
(x3,y3) (x2,y2)
on page 5-28.
5. Appendix
Slave Mode
(1279,0)
x
(1279,959)
(x4,y4)
(x1,y1)
F [5. 13