Confirming A Successful Read - IDEC WB2F User Manual

1. Overview 2. Installation & wiring
3. 2

Confirming a Successful Read

You can use the WB2F to confirm that a symbol was successfully read.
Operate based on the procedure below.
1
Place the symbol within the Reading Range
2
Push the READ/ENTER button while the power is ON
Emitter LED continuously lights up as reading begins
Due to the WB2F's settings, there are symbols that cannot be read. If you read a symbol double check the
settings to ensure that the symbol is enabled.
3
You can confirm the Status of a read simply by looking at the Status LED lights
During Reading Operation
Status LED
(R)
During
Reading Operation
The Status LED (Orange) will continuous-
ly be ON during Reading Operations but
will turn OFF once Reading Operations
are terminated
The Status LED settings can be changed. The settings here describe the default settings.
Operational Check
2D Code
Barcode
Read Success Time
(O) (G) (R)
Read Success
After a successful read the green status
LED will turn ON (300ms)
4. Function
Status LED
(O) (G)
After a read failure, or a reading timeout,
the red status LED will turn ON (300ms)
3-3
5. Appendix
Confirming a Successful Read
Power-ON Indicator LED
Read Failure
Status LED
(R) (O) (G)
Read Failure