Operation Mode Switching Operation And Status - IDEC WB2F User Manual

1. Overview 2. Installation & wiring
4. 1. 2

Operation mode switching operation and status

The operation mode is switched using the READ/ENTER button or communication commands.
For the communication commands, refer to
Master mode
For details on the operation modes, refer to the following.
Slave mode ................................................................
z
Setup support mode .............................................
z
Maintenance mode ................................................
z
Master Mode .............................................................
z
Be aware that if you change the operation mode without executing the control command "Save setting
values" after changing the set value, the set value will return to the state before change.
3 Operational Check
F [4. 2. 7 Communication command]
Normal usage
Unit power supply
Off
Unit power
supply On
Slave mode
F Page 4-4
F Page 4-41
F Page 4-50
F Page 4-53
4-3
Function 5. Appendix
on page 4-28.
Maintenance
mode
Setup support
mode
Overview