Symbol Read Data Confirmation - IDEC WB2F User Manual

1. Overview 2. Installation & wiring
3. 3

Symbol Read Data Confirmation

Confirm the data read by the WB2F by using a PC.
Operate based on the procedure below.
1
Install a generic terminal software onto the PC
WB2F's reading management will be done via the generic terminal software
2
Start up the generic terminal sfotware, select the port the WB2F is connected to and begin communications
The Connector Port can be viewed from [Device Manager]
Because you are connecting via USB, there is no need to separately set communication speed.
3
Place the symbol within the reading range
4
Transmit the following command from a PC to the WB2F
Emitter LED continuously lights up as reading begins
Request
Read Start
The prefix and suffix of Control Commands varies based on settings. The explanation in this manual as-
sumes that factory default settings have been maintained.
5
Read Data can be confirmed via PC from the data the WB2F transmits
Read results can be determined by checking the Read data.
Read Result
Read Success
Read Failure or
Read Time Out
The prefix and suffix of the read data varies based on settings. The explanation in this manual assumes
that factory default settings have been maintained.
Operational Check
Control command (Transmitted Data PC)
Prefix
^
Read Data (Data received from PC)
Global Prefix
— Such as 123456789
—
3-4
4. Function
Symbol Read Data Confirmation
Mnemonic
get
Barcode Data
?
5. Appendix
Suffix
CR LF
Global Suffix
CR LF
CR LF