Table of Contents
Advertisement
1. Overview
2. Installation & wiring
To select Standard tuning, push the SELECT button.
Position LED 2 will flash prior to Standard tuning switching to standby
mode.
To select Detailed tuning, push the SELECT button.
Position LED 1 will flash prior to Detail Tuning switching to standby
mode.
To select Custom Tuning, push the SELECT button.
Position LED 3 will flash prior to custom tuning switching to standby
mode.
When the SELECT button is pushed while LED 3 is blinking, the status LED (green) will flash, and the
z
Reading Success Rate measurement will changeover to execution standby mode.
If 5 seconds elapse with no operation, the WB2F will revert to the operation mode it was in prior to
z
switching.
3
Measurement begins once READ/ENTER button is pushed.
4
If READ/ENTER button is pushed again, Measurement will stop
Once complete, the unit will revert back to its operation mode prior
to switching.
3 Operational Check
Wait for Standard Tuning
Wait for Detailed Tuning
Wait for Custom Tuning
Measurement Start/ Measurement Finish
4-43
Function
5. Appendix
Setup support mode
(2)
to be executed.
(3)
Position LEDs
(2)
to be executed.
(3)
Position LEDs
(2)
to be executed.
(3)
Position LEDs
(1)
(4)
(1)
(4)
(1)
(4)
Advertisement
Table of Contents
