IDEC WB2F User Manual page 68

1. Overview 2. Installation & wiring
z Read Parameter Table Changeover
There are two types of methods for switching read parameter tables.
For details on the read parameter table changeover function and its various settings please refer to
on page 4-58.
Table Specification Mode .....................................
z
Sequence Mode.......................................................
z
- Read Success Sort ................................................
Specify Table mode
Specify the read parameter table to commence reading.
When using the specified mode, set the [read parameter table specification] to "00-07.
e.g. If [Read parameter table specification] is set to "00", reading will be
performed using only operation read parameter table 0.
Sequence Mode
Will switch Read Parameter tables and begin reading in accordance to the sequence table settings.
The [sequence table] is defined as the execution order for setting destinations in the read parameter table. A maximum of
32 can be registered.
Prior to using sequence mode, set the value for "read parameter table" to "FF".
e.g. Operation given the following:
Read Parameter Table Specification: FFH
Sequence Table Number:
Read Success Sort:
Sequence Table00:
Sequence Table01:
Sequence Table02:
3 Operational Check
F Page 4-32
F Page 4-32
F Page 4-33
Sequence Table 00
03H
Disabled
02H
Sequence Table 01
01H
05H
Sequence Table 02
4-32
Function 5. Appendix
F [Symbol Reading]
Read Parameter Table 0
Read Parameter Table 2
Read Parameter Table 1
Read Parameter Table 5
Slave Mode