Table of Contents
Advertisement
MSD-701UHD / 702UHD / 801UHD/ 802UHD Command Guide
@GCD / @SCD
Getting
Command
Response
Setting
Command
Response
Parameter
Getting
Command
example
Response
Description Getting the RS-232C transmission.
Setting
Command
example
Response
Description RS-232C connector operates in the mode set in "@GCF / @SCF RS-232C
Remarks
76
RS-232C transmission between control devices
@GCD
@GCD, mode
@SCD, mode
@SCD, mode
mode: RS-232C transmission
0 = OFF [Default],
RS-232C connector operates in the mode set in "@GCF / @SCF
RS-232C communication mode".
1 = OUT1B connector,
2 = OUT2B connector
3 = IN8 connector
Enabling communication between the RS-232C connector of the MSD
and the RS-232C connector of an HDC series receiver that is connected
to OUT1B or OUT2B connector. The RS-232C connector cannot be used
for communication command control from a PC to the MSD and control
command output from the MSD to an external device.
@GCD
@GCD,1
Enabling communication between the RS-232C connector of the MSD and the
RS-232C connector of an HDC series receiver that is connected to OUT1B
connector.
@SCD,0
@SCD,0
communication mode".
For RS-232C transmission, set the same values for communication settings of the
external device's (such as PCs) transmitter and receiver sides.
If "mode" is set to "0", the respons for setting command will be sent. If "mode" is
set to a value other than "0", the RS-232C connector accepts only @SCD
command.
Advertisement
Table of Contents
