Table of Contents
Advertisement
@GIS / @SIS
Getting
Command
Response
Setting
Command
Response
Parameter
Getting
Command
example
Response
Description Getting the setting of Automatic measurement of the start position.
Setting
Command
example
Response
Description Setting signal that is currently input from IN6 to "1" (Current input signal is not
Remarks
@GSM / @SSM
Getting
Command
Response
Setting
Command
Response
Parameter
Getting
Command
example
Response
Description Getting the set automatic measurement mode when unregistered signal is input.
Setting
Command
example
Response
Description Setting the automatic measurement to be executed when unregistered signal is
Remarks
MSD-701UHD / 702UHD / 801UHD/ 802UHD Command Guide
Automatic measurement of start position
@GIS
@GIS, mode_1, mode_2
@SIS, ch, mode
@SIS, ch, mode
mode_1-2 / mode: Automatic measurement
0 = All inputs from this input channel are not measured automatically.
1 = Current input signal is not measured automatically.
2 = Current input signal is measured automatically. [Default]
ch: Input channel
0 =All analog inputs, 6 = IN6, 7 = IN7
@GIS
@GIS,0,2
IN6: not measured automatically, IN7: measured automatically.
@SIS,6,1
@SIS,6,1
measured automatically).
These commands are only for analog input.
IN6 and IN7 are available only if "0" (Analog signal) is selected for "@GIN / @SIN
Signal selection of DVI input connector". If "1" (Digital signal) is selected, "-1" is
returned.
Automatic measurement when unregistered signal is input
@GSM
@GSM, mode
@SSM, mode
@SSM, mode
mode: Automatic measurement
0 = Not execute, 1 = Execute [Default]
@GSM
@GSM,1
Automatic measurement is set to "1" (Execute).
@SSM,1
@SSM,1
input.
－
47
Advertisement
Table of Contents
