IDK MSD-701UHD Command Reference Manual page 48

MSD-701UHD / 702UHD / 801UHD/ 802UHD Command Guide
@RTT
Setting Command
Response
Parameter
Setting Command
example Response
Description
Setting Command
example Response
Description
Remarks
@STT
Setting Command
Response
Parameter
Setting Command
example Response
Description Saving IN7 input timing setting in device table 2 without editing the device table
Setting Command
example Response
Description Saving the current IN7 input timing setting in device table 2 with the name of
Remarks
48
Loading device data
@RTT, ch (, table)
@RTT, ch (, table)
ch: Input channel
1 = IN1 to 8 = IN8
table: Device table
1 to 99 (Registered device data),
100 to 100+n (Preset device data. "n" varies depending on input signal,
but 0 for most cases.)
Only for analog input, specify the device table.
@RTT,1
@RTT,1
Reconfiguring IN1 input timing setting to the value detected automatically.
@RTT,6,2
@RTT,6,2
Setting IN6 input timings to the values saved in the device table 2.
This command is valid only if signal is input.
For analog input, this command is valid only if the device data of input signal is
registered.
Registering device data
@STT, ch, table (, name)
@STT, ch, table (, name)
ch: Input channel
6 = IN6, 7 = IN7
table: Device table
1 to 99
name: Device table name
Up to 14 characters from 20 to 7D of ASCII code.
You can skip "Device table name". If you skip it, only input timing setting is saved.
However, if no device table name is currently saved, the resolution is saved
automatically as the device table name.
@STT,7,2
@STT,7,2
name.
@STT,7,2,XGA 60Hz
@STT,7,2,XGA 60Hz
"XGA 60Hz".
This command is valid only if analog RGB / YPbPr signal is input.