Removing And Installing The Lens - Christie GS Series Manual

Hide thumbs Also See for GS Series:

Table of Contents

Removing and installing the lens

Warning! Failure to comply with the following could result in death or serious injury.

• Turn off the projector and remove the power cord, before installing or replacing a lens.

When handling the projector after lens installation, make sure the front lens cap is placed on the

lens to protect the lens surface from potential damage. When carrying or moving the projector, do

not handle by the lens. This may damage the lens, the chassis, or other mechanical parts within the

projector.

1. Center the lens. Ensure the lens is at or near its center position. Attempting to remove the lens

with a large offset may cause damage to the lens assembly.

Center the lens while the projector is switched on by pressing the Lens Horizontal or Lens

Vertical button and then pressing Enter.

2. Turn off the projector.

3. Allow the projector to cool down into standby mode before replacing the lens.

4. After the projector has cooled down and prior to replacing the lens, remove the power cord.

5. To remove the lens, remove the lens ring cover first. Then press the Lens Release button

with a tool and rotate the lens counterclockwise by a quarter

Remove the lens through the front of the projector.

6. To install the new lens, fully insert the lens assembly straight into the lens mount without

turning. Rotate the lens cap clockwise to lock the lens in place.

DWU6322-GS/DWU7062-GS User Manual

020-001792-01 Rev. 1 (04-2020)

Installation

to release the lock.

Table of Contents

Dwu6322-gs Dwu7062-gs