Aligning The Lamp - Christie CP2308 User Manual

Aligning the lamp

Complete the following procedure to align the lamp.
1. In the left navigation menu, tap Lamp Settings > Lamp Power/LiteLOC Setup.
2. Under Lamp Power, verify that the lamp power settings are suitable for your requirements.
3. In the left navigation menu, tap Lamp Settings > Lamp Adjust.
4. Tap the Display White Test Pattern slider.
5. Complete a coarse lamp adjustment.
a) Locate the Y axis adjustment label on the operator side of the projector
b) Insert a 5 mm hex driver through the louvers at an angle below the Y axis adjustment
label until it is firmly seated on the Y axis adjustment screw.
c) Turn the screw clockwise or counterclockwise until the value in the Intensity field peaks
and then reduces.
d) Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
6. Complete a fine lamp adjustment.
a) Locate the Y axis adjustment label on the operator side of the projector.
b) Insert a 5 mm hex driver through the louvers at an angle below the Y axis adjustment
label until it is firmly seated on the Y axis adjustment screw.
CP2308 User Guide
020-102535-03 Rev. 1 (08-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Managing lamp settings
23