Replacing The Auxiliary Cooling Fan Of The Drive Module (Frames R6 To R9) - ABB ACS880-07 Hardware Manual

Replacing the auxiliary cooling fan of the drive module (frames R6

to R9)
WARNING! Obey the instructions in chapter
ignore them, injury or death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section
16 before you start the work.
2. Unplug the power supply wires from the control unit terminal X208:FAN2.
3. Lift the fan up.
4. Install the new fan in reverse order. Make sure that the arrow on the fan points up.
3
2
2
Safety
Precautions before electrical work
Maintenance 149
instructions. If you
on page