Mcs Coupling (Te6); Signals To Axis/Spindle (Db31; Signals From Axis/Spindle (Db31 - Siemens SINUMERIK 840D sl Function Manual

Z3: NC/PLC interface signals

21.10 MCS Coupling (TE6)

21.10 MCS Coupling (TE6)
21.10.1

Signals to axis/spindle (DB31, ...)

DB31, ...
DBX24.2
Edge evaluation: No
Signal state 1
Signal state 0
Signal irrelevant for ...
Application example(s)
DB31, ...
DBX24.3
Edge evaluation: Yes
Signal state 1
Signal state 0
Signal irrelevant for ...
Application example(s)
21.10.2

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX66.0
Edge evaluation: No
Signal state 1
Signal state 0
DB31, ...
DBX97.0
Edge evaluation: No
Signal state 1
Signal state 0
748
Deactivate or disable coupling
Signal(s) updated:
An active coupling is not deactivated until the relevant axes are stationary. If CC_COPON is
programmed for this axis, no error message is generated.
Coupling may be activated
Evaluated only on the CC_Slave axis.
Switch on collision protection
Signal(s) updated:
Collision protection ON
Collision protection OFF
This signal is processed only if collision protection is not activated via machine data:
MD65543 $MA_CC_PROTECT_OPTIONS
Evaluated only on the PSlave axis.
Activate monitor
Signal(s) updated:
Monitoring is active.
This readout must be activated by the PSlave axis in the the following machine data:
MD63543 $MD_CC_PROTECT_OPTIONS
Note:
Conflicts may occur in connection with customer-specific compile cycles.
Monitor is not active.
Axis is a slave axis
Signal(s) updated:
Axis is a CC_Slave axis.
The associated CC_Master axis can be found in the machine data.
Axis is not a CC_Slave axis
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
Special Functions