Siemens SINUMERIK 840D sl Function Manual page 749

DB31, ...
DBX97.1
Edge evaluation: No
Signal state 1
Signal state 0
Signal irrelevant for ...
Application example(s)
DB31, ...
DBX97.2
Edge evaluation: No
Signal state 1
Signal state 0
Signal irrelevant for ...
Application example(s)
DB31, ...
DBX97.3
Edge evaluation: Yes
Signal state 1
Signal state 0
Signal irrelevant for ...
Application example(s)
Special Functions
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
Activate coupling
Signal(s) updated:
Coupling active
Coupling not active
Displayed only for the CC_Slave axis.
Activate mirroring
Signal(s) updated:
Mirroring active (1:-1)
1:1 coupling active
Relevant only if coupling is active (DBX97.1 = 1)
Displayed only for the CC_Slave axis.
Offset after point of activation
Signal(s) updated:
New offset after point of activation.
This bit is set to 1 if a particular event (SW/HW limit switch on CC_Slave axis) causes a change
in the offset between CC_Master and CC_Slave stored when the coupling was activated.
No new offset since activation.
The bit is not set in the RESET phase.
Displayed only for the CC_Slave axis.
Z3: NC/PLC interface signals
21.10 MCS Coupling (TE6)
749