Data Lists; Machine Data; Nc-Specific Machine Data; Channel­specific Machine Data - Siemens SINUMERIK 840D sl Function Manual

5.9

Data lists

5.9.1

Machine data

5.9.1.1

NC-specific machine data

Number Identifier: $MN_
11410 SUPPRESS_ALARM_MASK
11660 NUM_EG
11750 NCK_LEAD_FUNCTION_MASK
11752 NCK_TRAIL_FUNCTION_MASK
18400 MM_NUM_CURVE_TABS
18402 MM_NUM_CURVE_SEGMENTS
18403 MM_NUM_CURVE_SEG_LIN
18404 MM_NUM_CURVE_POLYNOMS
18406 MM_NUM_CURVE_TABS_DRAM
18408 MM_NUM_CURVE_SEGMENTS_DRAM
18409 MM_NUM_CURVE_SEG_LIN_DRAM
18410 MM_NUM_CURVE_POLYNOMS_DRAM
18450 MM_NUM_CP_MODULES
18452 MM_NUM_CP_MODUL_LEAD
5.9.1.2 Channel­specific machine data
Number Identifier: $MC_
20110 RESET_MODE_MASK
20112 START_MODE_MASK
22620 START_MODE_MASK_PRT
22621 ENABLE_START_MODE_MASK_PRT
20900 CTAB_ENABLE_NO_LEADMOTION
20905 CTAB_DEFAULT_MEMORY_TYPE
21300 COUPLE_AXIS_1
Special Functions
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
Description
Mask for supporting special alarm outputs
Number of possible electronic gears
Functions for master value coupling
couple motion functions
Number of curve tables (SRAM)
Number of curve segments (SRAM)
Number of linear curve segments (SRAM)
Number of curve table polynomials (SRAM)
Number of curve tables in DRAM
Number of curve segments in DRAM
Number of linear curve segments (DRAM)
Number of curve polynomials in DRAM
Maximum number of allowed CP coupling modules
Maximum number of allowed CP master values
Description
Definition of control basic setting after run-up and
RESET/part program end
Definition of control basic setting after run-up and
RESET
Definition of the control basic settings for special start
Activation of MD22620
Curve tables with jump of following axis
Default memory type for curve tables
Projection synchronous spindle pair
M3: Coupled axes
5.9 Data lists
357