Starting Up A Kinematic Transformation - Siemens SINUMERIK 840D sl Function Manual

Inserting the PC card
1. Deactivate the control.
2. Insert the PC card with the new firmware (technology card) in the PCMCIA slot of the
NCU.
3. Turn switch S3 on the front panel of the NCU to 1.
4. Switch the control system back on again.
5. During run-up, the firmware is copied from the PC card to the NCU memory.
6. Wait until number "6" is displayed on the NCU digital display (after approximately one
minute).
7. Turn switch S3 back to zero.
If number "6" does not appear, an error has occurred.
•
•
Copy back SRAM contents
Note
The exact procedure of resaving the backed up data in the control is described in:
References:
/IAD/ SINUMERIK 840D Start-up Instructions; Chapter "Data Backup"
Please read all information provided by the manufacturer about new software versions.
1. Enter the machine manufacturer password.
2. Select "Data in" and "Archive...". Then load the archive with backup compensation data (if
applicable).
13.14.2

Starting up a kinematic transformation

The next step necessary to start up the kinematic transformation is to activate the handling
transformation package (option).
Set the option data for handling transformation package.
Interrupts
Record the alarm texts in the corresponding language-specific text files.
Set option data for transformation.
Special Functions
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
CAUTION
Incorrect PC card (e.g. card for NCU2 in NCU3 hardware)
Card hardware is defective
TE4: Transformation package handling
13.14 Examples
593