6. In the directory for the manufacturer cycles, create the file "TRAORI.SPF" with the
following contents:
PROC TRAORI(INT II)
RET
7. In the directory for the manufacturer cycles, create the file "TRACON.SPF" with the
following contents:
PROC TRACON(INT II)
RET
Note
The "TRAORI.SPF" and "TRACON.SPF" manufacturer cycles created under 6. and 7.
must not be loaded onto the NC.
8. Start the simulation.
9. Run a data comparison for the cycles after the simulation has started up:
-
Special Functions
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
HMI Advanced: Data comparison > Compare cycles
Note
At least the password for protection level 3 "End user: Service" is needed for the data
comparison.
TE02: Simulation of compile cycles
10.2 OEM transformations
453