Siemens SINUMERIK 840D sl Function Manual page 222

M3: Coupled axes
5.2 Curve tables
• applim:
Behavior at the curve table edges.
- 0 non-periodic (table is processed only once, even for rotary axes).
-
-
• Master value
Position value for which a following value is to be determined.
• Slave value
Position value for which a master value is to be calculated.
• aproxmastervalue
Position value that can be used to determine a unique master value in the case of an
ambiguous reversing function of the curve table.
• degrees
Parameter in which the pitch of the table function is returned.
• memType
Optional parameter for specifying memory type to be used n curve tables.
Possible values:
"SRAM" curve table is created in static NC memory.
"DSRAM" curve table is created in dynamic NC memory.
If an invalid type is entered, the value 2 is returned.
If the parameter is omitted, then the memory type set via the following machine data takes
effect:
MD20905 $MC_CTAB_DEFAULT_MEMORY_TYPE (default memory type for curve
tables)
• segType
Optional parameter for entry of segment type
Possible values:
segType "L" linear segments
segType "P" Polynomial segments
References:
/PGA/ Programming Manual Work Preparation; Path Behavior Chapter Curve Tables
(CTAB)
222
1 periodic, modulo (the modulo value corresponds to the LA table values).
2 periodic, modulo (LA and FA are periodic).
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
Special Functions